TRIUMPH TR6
PLATE GW
SPECIAL SERVICE TOOLS, SECTION III
DIFFERENTIAL, REAR AXLES,
AND REAR HUBS
99
SPECIAL SERVICE TOOLS, SECTION III--DIFFERENTIAL, REAR AXLES, AND REAR HUBS
Note:
Special service tools for Triumph cars were
manufactured and distributed by Messrs. V.L. Churchill
and Company, now located in Daventry, Northants.
Although most of these tools are now unavailable, we
are listing them here with illustrations for your
information. We have also produced special runs of a
few of these tools, and we will produce more if
demand exists.
CHURCHILL DIFFERENTIAL SERVICE TOOLS
Spreader,
differential case
1
Adaptor,
differential case spreader
1
Wrench,
for holding pinion flange
1
Wrench,
for holding pinion flange (Alternative to CLRG421.)
1
Adaptor Set,
differential carrier side bearing remover
1
(Used with CL47, Multi-Purpose Hand Press.)
Remover,
pinion bearing races
1
Replacer,
pinion bearing races
1
Adaptor Set,
remover/replacer, pinion head bearing
1
cone (Used with CL47, Multi-Purpose Hand Press.)
Gauge,
pinion setting (Used with CLM84B-1, Dummy
1
Pinion and Bearing Set.)
Dummy Pinion and Bearing Set
(Used with CLM84B.)
1
Gauge,
setting, pinion pre-load
1
CHURCHILL SERVICE TOOLS FOR REAR AXLES AND
REAR HUBS
REMOVER,
rear hub, hydraulic
1
Repair Kit,
hydraulic seals
1
Adaptor Set,
remover/replacer, outer hub bearing
1
from/to outer axle flange (Used with CL47,
Multi-Purpose Hand Press.)
Jig,
rear hub assembly
1
CLS317
Wrench,
adjusting, rear hub bearings
1
Plate No.
Part No.
Description
No. Off
Plate No.
Part No.
Description
No. Off
