TRIUMPH TR6
PLATE GV
SPECIAL SERVICE TOOLS, SECTION II
GEARBOX AND OVERDRIVE
98
SPECIAL SERVICE TOOLS, SECTION II--GEARBOX AND OVERDRIVE
Note:
Special Service tools for Triumph cars were
manufactured and distributed by the Messrs. V.L.
Churchill and Company now located in Daventry,
Northants. Although most of these tools are now
unavailable, we are listing them here with illustrations
for your information. We have also produced special
runs of a few of these tools, and we will produce more
if demand exists.
CHURCHILL GEARBOX SERVICE TOOLS
Wrench,
for holding rear drive flange
1
Wrench,
for holding rear drive flange (Alternative to
1
CLRG421.)
Adaptor,
input shaft remover (Used with CL4235A, Slide
1
Hammer.)
Adaptor Set,
input shaft bearing remover/replacer,
1
mainshaft center bearing remover (Used with CL47,
Multi-Purpose Hand Press.)
Driver,
for installation of closed-cage countershaft
1
needle bearings
Remover,
mainshaft circlip
1
Replacer,
mainshaft circlip
1
Bearing Driver/Abutment Plate Set,
replacing main
1
shaft rear bearing
CHURCHILL A-TYPE OVERDRIVE SERVICE TOOLS
PRESSURE TEST EQUIPMENT,
including gauge, hose,
1
and adaptor
Hose,
pressure test
1
Adaptor Set,
tailshaft bearing remover/replacer (Used
1
with CL47, Multi-Purpose Hand Press.)
Remover,
accumulator piston housing
1
Remover,
pump barrel
1
Adaptor
(Used with CLL183A, Pump Barrel Remover.)
1
Dummy Drive Shaft
1
Jig,
freewheel assembly
1
Replacer,
oil pump body
1
CHURCHILL J-TYPE OVERDRIVE SERVICE TOOLS
PRESSURE TEST EQUIPMENT,
including gauge, hose,
1
and adaptor
Hose,
pressure test
1
Adaptor,
pressure take-off
1
Adaptor,
pressure, spline release
1
Adaptor,
spanner, oil pump plug
1
Remover/Replacer Tool,
relieve valve body and
1
dashpot sleeve
Jig,
freewheel assembly
1
Plate No.
Part No.
Description
No. Off
Plate No.
Part No.
Description
No. Off