The Roadster Factory
TR6 - TR250 Glove Box Companion
A B C D E F G H I-J K L M N-O P R S T U-V W-Z
LOGIN | VIEW CART | CHECKOUT
View Shopping Cart -
Search
                      10       < Previous Next >       10        
Page Map
Bonnet Prop Rods, TR250, TR6 Door Glass, TR250, TR6 Bonnet Side Buffers And Bonnet Locating Cones, TR250, TR6 Trunk Lid Prop Rods, TR250, TR6 Chromed Trunk Lid Hinges, TR250 Rear License Plate Brackets, TR250, TR6 Trunk Lid Locking Handles And Latches, TR250 Badges, TR250 Bonnet Stripe Measurements, TR250 Grille Badges, TR6 Rear Apron Badges, TR6
Scroll to view page
TR250 and TR6 Companion
227
BONNET RELEASE CABLES, TR250, TR6
"Back-up Bonnet Release Kits Are Popular Too..."
Don't wait till a frayed cable breaks as some have done...  The next
step after the cable breaks is to take a can opener to the bonnet to get it
open!  Actually, it is not necessary to damage the bonnet to get it open,
but getting it open again after a cable breaks can be difficult.  Fitting the
little trunnion to the end of the cable is one insurance policy.  Another is
to fit the back-up bonnet release kit, which is a very popular solution, as
TRF sells several hundred of these kits every year.
Part No.
Description
No. Off
List Price
Your Price
Bonnet Release Cable,
inner, with handle
1
11.95
Bonnet Release Cable,
outer, with bezel
1
11.95
Grommet,
rubber, sealing bonnet release
1
1.45
cable
Trunnion Fitting,
with clamp screw, for
1
2.95
securing cable
Clip,
bonnet cable to bonnet catch
1
1.95
Back-up Bonnet Release Kit,
if the worst
1
39.95
thing happens
BODY TRIM AND FITTINGS
Part No.
Description
No. Off
List Price
Your Price
Bonnet Latch Assembly,
with safety hook;
1
36.95
this is the part on the bonnet
Catch Plate,
bonnet latch; this is the part
1
39.95
on the bulkhead
HARDWARE KIT,
securing latch to bonnet
1
2.95
Screw,
set
2
.85
Washer,
lock
2
.45
Washer,
plain
2
.45
HARDWARE KIT,
securing catch plate to
1
3.95
bulkhead
Screw,
set
4
.85
Washer,
lock
4
.45
Washer,
plain
4
.45
BONNET LATCHES, TR250, TR6
"TRF Manufactures Both the Latch and the Catch Plate"
The Roadster Factory has manufactured its own
bonnet latches which have a reinforced safety hook
designed to last longer than original components.
We also manufacture the catch plate as well, and we
supply little kits which contain the correct hardware
for installation.  These parts are always in stock, as
we make one-thousand each time.

                      10       < Previous | | | | | | Next >       10        

This Zenscript (Print to E-Commerce) catalog conversion was performed by zeni.net internet services. If you have questions about this interface, contact support@zeni.net. Cookies and Javascript must be enabled for online ordering, but these pages should render in a viewable manner in any style-sheet capable browser.